Electrolux Washer/Dryer Combo LGH1642DS0 Parts

Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

Washer door strike. If the washing machine won't start, inpsect the actuator for damage. If the actuator is damaged the door will not latch properly and the washer will not turn on.

Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.

Dryer drum glide. These drum glides help to support the front of the dryer drum as it rotates. Sold individually. It is recommended to replace both at one time.

Door lock & switch assembly

Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.

Shock mounting pin

Bearing cup for drum support ball

Lower felt for drum seal

Idler pulley and arm, dryer

Washing machine shock absorber kit. The shock absorbers dampen the vibration of the washer tub. If one or more of the shock absorbers are worn out, the washer will vibrate or shake.

The Frigidaire Blower Wheel 131476300 is a high-quality part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. Recommended to use safety equipment. Disconnect the appliance before repair. Consult the owner's manual for instructions.

Upper seal for drum seal

The high quality Frigidaire Control Knob (131873304 ) allows for control cycle settings. The Control Knob knob is easy to remove by pulling it straight off its post and is approximately 2.5 inches in diameter. Please be aware that it is recommended to use saftey equipment and to disconnect the appli