Unlock the Right Part
for Your Repair
Find the exact part you need
Enter your model number to see parts that fit your machine.
Choose Product
Identify Problem
03
Find Solutions
HomeRepair HelpSpeed Queen Washer RepairSpeed Queen Washer filling when not in use Repair
Speed Queen Washer filling when not in use
If your Speed Queen washer is filling with water when off, water is entering the tub even though the cycle is not running. The most likely cause is a defective water inlet valve. This valve should close when power is removed, but a failing valve can allow water to continue flowing into the washer. Check household water pressure first, since the valve needs at least 20 psi to operate and shut off properly. Low pressure can keep the valve from closing fully, especially if a whole-house filter is clogged or water pressure is low at other faucets. If pressure is adequate, inspect the filter screens in the water inlet valve and fill hoses. Debris can restrict flow or prevent the valve from sealing. Unplug the washer, shut off both water supply valves, place a bucket under the hoses, and clean the screens before reconnecting them. These steps address common reasons for a washing machine filling with water when off or water in the washing machine drum when not in use. Enter your Speed Queen model number to find the exact water inlet valve or other replacement part for your specific washing machine.
01 - Speed Queen Washing Machine Water Inlet Valve
The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all. The water inlet valve requires at least 20 psi to function properly. First, check the water pressure to determine that it is adequate. If the water pressure is adequate, replace the water inlet valve.
Enter model number to search for the required part specific to your product
Top Solution
02 - Low Water Pressure from House Supply
The water inlet valve requires good water pressure to shut off properly. If the home's water pressure is too low, the valve may not close fully after the power is shut off causing water to leak into the washer when not in use. If you have a whole house filter it may be clogged and the filter needs to be replaced. If the water pressure is low at all the faucets, you may need to call your local water supplier to determine if the water pressure is sufficient.
Highly Likely
03 - Clogged Screens in Fill Hose or Water Inlet Valve
All water valves have filter screens to prevent particles from clogging the valve or stop the valve from closing. For added protection and easier access, some fill hoses may have screens added to the hose washers/gaskets where the fill hose connects to the homes hot or cold shut-off valve. The screens in the water valve and hoses should be checked and cleaned if necessary. Unplug the machine. Turn off the water supply valves. Get a bucket to catch the remaining water in the hoses. Unthread the hoses from your machine and clean any debris from the filter screens.
Common
Frequently Asked Questions
Why is my Speed Queen washer filling with water when it is turned off?
Can low water pressure cause a Speed Queen washer to keep filling when it is off?
How do I clean the fill hose and water inlet valve screens?
How can I test the Speed Queen water inlet valve before replacing it?
How do I find the correct Speed Queen water inlet valve for my washer?