Unlock the Right Part
for Your Repair
Find the exact part you need
Enter your model number to see parts that fit your machine.
Choose Product
Identify Problem
03
Find Solutions
HomeRepair HelpRoper Washer RepairRoper Washer filling when not in use Repair
Roper Washer filling when not in use
When your Roper washer is filling with water when off, water in the washing machine drum when not in use, or the washer keeps filling with water after a cycle, the water inlet valve is the most likely cause. This valve should shut completely when the washer is not running, but a defective valve can allow water to seep into the tub. Check the household water pressure next, because low pressure can prevent the valve from closing properly. A clogged whole-house filter may reduce pressure at the washer and other faucets. Finally, inspect the filter screens in the fill hoses and water inlet valve for dirt or debris that may keep the valve from sealing. Unplug the washer, shut off both water supply valves, and clean the screens before replacing parts. This troubleshooting applies to Roper washing machines, including top-load models. Enter your model number to find the exact water inlet valve or other replacement part for your specific washing machine. If water continues entering the tub with the supply hoses disconnected, the problem may be elsewhere in the plumbing.
01 - Roper Washing Machine Water Inlet Valve
The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all. The water inlet valve requires at least 20 psi to function properly. First, check the water pressure to determine that it is adequate. If the water pressure is adequate, replace the water inlet valve.
Enter model number to search for the required part specific to your product
Top Solution
02 - Low Water Pressure from House Supply
The water inlet valve requires good water pressure to shut off properly. If the home's water pressure is too low, the valve may not close fully after the power is shut off causing water to leak into the washer when not in use. If you have a whole house filter it may be clogged and the filter needs to be replaced. If the water pressure is low at all the faucets, you may need to call your local water supplier to determine if the water pressure is sufficient.
Highly Likely
03 - Clogged Screens in Fill Hose or Water Inlet Valve
All water valves have filter screens to prevent particles from clogging the valve or stop the valve from closing. For added protection and easier access, some fill hoses may have screens added to the hose washers/gaskets where the fill hose connects to the homes hot or cold shut-off valve. The screens in the water valve and hoses should be checked and cleaned if necessary. Unplug the machine. Turn off the water supply valves. Get a bucket to catch the remaining water in the hoses. Unthread the hoses from your machine and clean any debris from the filter screens.
Common
Frequently Asked Questions
Why is my Roper washing machine filling with water when it is turned off?
Can low water pressure cause a washer to keep filling when it is not in use?
How do I check the water inlet valve on a Roper washer?
How do I clean clogged fill hose or water inlet valve screens?
How do I find the correct Roper water inlet valve replacement part?