Unlock the Right Part
for Your Repair
Find the exact part you need
Enter your model number to see parts that fit your machine.
Choose Product
Identify Problem
03
Find Solutions
HomeRepair HelpAmana Washer RepairAmana Washer filling when not in use Repair
Amana Washer filling when not in use
If your Amana washer is filling with water when it is off, the water inlet valve is the most likely cause. This valve should close when the wash cycle ends, but a defective valve can allow water to continue entering the tub, resulting in a washing machine filling with water when off or water in the washing machine drum when not in use. First, check the household water pressure, because low pressure can prevent the inlet valve from shutting off completely. A clogged whole-house filter may restrict pressure at the washer and other faucets. If pressure is adequate, inspect the screens in the water inlet valve and fill hoses for sediment or debris. Unplug the washer, turn off both water supply valves, place a bucket under the hoses, and clean the screens carefully. Replace the water inlet valve if it will not close properly after these checks. Enter your model number to find the exact replacement water inlet valve or other Amana washer part made for your specific washing machine. Test water pressure before ordering, and never service the washer while it is connected to power or water.
01 - Amana Washing Machine Water Inlet Valve
The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all. The water inlet valve requires at least 20 psi to function properly. First, check the water pressure to determine that it is adequate. If the water pressure is adequate, replace the water inlet valve.
Enter model number to search for the required part specific to your product
Top Solution
02 - Low Water Pressure from House Supply
The water inlet valve requires good water pressure to shut off properly. If the home's water pressure is too low, the valve may not close fully after the power is shut off causing water to leak into the washer when not in use. If you have a whole house filter it may be clogged and the filter needs to be replaced. If the water pressure is low at all the faucets, you may need to call your local water supplier to determine if the water pressure is sufficient.
Highly Likely
03 - Clogged Screens in Fill Hose or Water Inlet Valve
All water valves have filter screens to prevent particles from clogging the valve or stop the valve from closing. For added protection and easier access, some fill hoses may have screens added to the hose washers/gaskets where the fill hose connects to the homes hot or cold shut-off valve. The screens in the water valve and hoses should be checked and cleaned if necessary. Unplug the machine. Turn off the water supply valves. Get a bucket to catch the remaining water in the hoses. Unthread the hoses from your machine and clean any debris from the filter screens.
Common
Frequently Asked Questions
Why is my Amana washer filling with water when it is turned off?
How do I know if my Amana washer water inlet valve is bad?
Can low water pressure cause a washer to keep filling with water?
How do I clean the fill hose or water inlet valve screens on an Amana washer?
How do I find the correct Amana washer water inlet valve?