If your Amana washer dispenser is not working, detergent, bleach, or fabric softener may remain in the drawer or wash into the tub without being diluted properly. The most likely cause is low household water pressure or a defective water inlet valve, which supplies water to flush the dispenser. The valve needs at least 20 psi to operate correctly, so check water pressure before replacing it. Next, inspect the detergent container for clogs, misalignment, or damage, then check the dispenser drawer for obstructions or cracks. These are common detergent dispenser problems and can cause a washer not dispensing detergent or a washing machine not dispensing detergent. If your fabric softener dispenser problems include diluted softener left in the tray, clean the dispenser compartments and siphon break or siphon tube, since a plugged tube can prevent proper siphoning. If water pressure and the dispenser parts are good, the control board may not be sending power at the correct time. Use a multimeter to test the circuit before replacing the board. Enter your model number to find the exact replacement water inlet valve, dispenser, drawer, detergent container, siphon break, or control board for your Amana washing machine.
01 - Amana Washing Machine Water Inlet Valve
The dispenser uses water from the inlet valve to flush out the detergent and fabric softener from the dispenser. If the water flow is too slow the dispenser will not distribute the detergent and softener properly. The water inlet valve requires at least 20 psi to function properly. First, check the water pressure to determine that it is adequate. If the water pressure is adequate, replace the water inlet valve.
Enter model number to search for the required part specific to your product
The dispenser's detergent container could be clogged, misaligned, or damaged, and unable to dispense its contents properly. Inspect the detergent container for any damage and replace if necessary.
A washer detergent dispenser not working is often the result of low water pressure in the home or a defective water inlet valve not supplying water to the dispenser. However, it's also possible the dispenser drawer is obstructed or damaged and not allowing the detergent to be dispensed. You should inspect the drawer for any obstructions or damage and replace the component if necessary.
Some dispensers use a siphon tube. If the siphon tube gets plugged you may get a diluted mixture of detergent, bleach, or fabric softener remaining in the tray. Make sure the dispenser compartment trays and siphon tubes are clean.
A washer detergent dispenser not working is often the result of low water pressure in the home or a defective water inlet valve not supplying water to the dispenser. However, it's also possible the appliance's control board is not sending power to the dispenser water valves or dispenser actuator at the proper times. You can use a multimeter to help determine if voltage is reaching these components. If not, the control board will need to be replaced.
A washer dispenser not working is often the result of low water pressure in the home or a defective water inlet valve not supplying water to the dispenser. However, it's also possible the dispenser drawer is obstructed or damaged and not allowing the detergent, bleach, or fabric softener to be dispensed. You should inspect the drawer for any obstructions or damage and replace the component if necessary.
Most washer dispensers use a water inlet valve to move water through the different dispenser compartments at specified times to dispense the soap or fabric softener. Some models use a diverter motor. If the dispenser is clogged and cannot be cleaned or the water inlet valve is part of the dispenser and no water is flowing through it, the dispenser will need to be replaced.