When your Amana washer is leaking, start by checking the drain pump, the most likely source. A cracked pump, damaged housing, or worn pump bearing can cause a washer leaking from the bottom, and the drain pump must be replaced rather than repaired. Next, inspect the hoses, including the tub-to-pump hoses, for splits, loose connections, or damaged clamps. A torn tub seal can also let water reach the tub bearings, so replace the tub seal and tub bearing kit together when needed. This is a major repair that requires substantial washer disassembly. If the leak is near the front, make sure the dispenser drawer is fully closed and check it for cracks or damage. On a front load washer leaking from the door area or underneath, use only HE detergent and the recommended amount. Excess or incorrect detergent creates too many suds, which can escape through the overflow system. Whether you have a washing machine leaking during fill, wash, or drain, disconnect power and water before inspecting parts. Enter your Amana washer model number to find the exact replacement drain pump, hose, seal, bearing kit, or dispenser drawer for your specific washing machine.
01 - Amana Washing Machine Hose
Hoses apart from the fill hose or drain hose could be reponsible for a leaking washer. You should inspect all of the appliance's hoses, such as tub-to-pump hoses, for damage or loose connections and replace if necessary.
Enter model number to search for the required part specific to your product
The drain pump pumps water out the drain hose. If the drain pump is cracked or damaged, or if the bearings are worn out, the drain pump may leak water. The drain pump is not repairable—if the pump is leaking water, replace it.
03 - Amana Washing Machine Tub Seal and Bearing Kit
The tub seal might be torn, causing water to leak from the seal. If the tub seal is leaking water, water may leak through the tub seal and into the tub bearings. This can cause the bearings to fail. For this reason, if the tub seal is leaking water, replace both the tub seal and the tub bearings. Be aware that this is a complicated repair and will require disassembling most of the washer.
The tub seal might be torn, causing water to leak from the seal. If the tub seal is leaking water, water may leak through the tub seal and into the tub bearings. This can cause the bearings to fail. For this reason, if the tub seal is leaking water, replace both the tub seal and the tub bearings. Be aware that this is a complicated repair and will require disassembling most of the washer.
If a washer is leaking water, you should confirm the dispenser drawer is completely closed and free of damage. If the drawer is cracked, the component could be responsible for the leak and should be replaced.
If you have a front-load washer, be certain that you are using an HE - high efficiency - detergent. HE detergent is formulated to be low-sudsing and to be used with the lower water levels utilized by front-load washers. Front-load washers have a small overflow system usually on the back of the appliance. If you have too many suds, they are probably escaping from there.
Highly Likely
07 - Amana Washing Machine Tub-to-Pump Hose
The tub-to-pump-hose might be split or torn. If the tub-to-pump-hose is damaged, replace it. Do not attempt to cut off the damaged piece of hose and stretch the hose to fit the pump. Stretching the hose will put strain on the remainder of the hose and may cause the hose to suddenly rupture.