Choose Product
Identify Problem
03
Find Solutions
HomeRepair HelpRCA Washer RepairRCA Washer won't stop Repair

RCA Washer won't stop

When your RCA washer won't stop, first check for water siphoning from the tub. The drain hose may be positioned too low, sealed tightly in the standpipe, or pushed too far down, allowing water to drain continuously and making the washer keep running or appear stuck on a cycle. The hose should typically end 30 to 36 inches above the floor in a standpipe or laundry tub, according to the model instructions. If the washer drains normally but the washing machine won't stop, a defective control board is the next likely cause. Inspect the control board for burned areas or shorted components, but note that it is difficult to test. A faulty main control board can cause the same washer not stopping problem. If both boards appear sound, the timer may be defective. Test the timer with a multimeter and the wiring diagram before replacing it. Always disconnect power before inspecting internal parts. Enter your RCA washer model number to find the exact replacement control board, main control board, or timer for your specific machine.

01 - Water siphoning from tub

If the water is siphoning from the tub the outlet end of the drain hose is likely lower than the water level in the tub. The drain hose should terminate between 30 inches to 36 inches (77 centimeters to 92 centimeters) above the floor, depending on the model, in a standpipe or laundry tub. If the drain hose is sealed at the top of the standpipe or excess hose is pushed too far down into the pipe, siphoning can also occur.
Common

02 - RCA Washing Machine Timer

If the washer can successfully drain the water from the tub then a defective timer could be responsible for the washer not stopping. You can test the timer by using a multimeter and consulting the wiring diagram. If the timer is defective, replace it.
Enter model number to search for the required part specific to your product
Need help finding your model number?
Shop all RCA Washing Machine Timer Parts
Less Common

03 - RCA Washing Machine Control Board

If the washer can successfully drain the water from the tub then a defective control board could be responsible for the washer not stopping. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Shop all RCA Washing Machine Control Board Parts
Less Common

04 - RCA Washing Machine Main Control Board

If the washer can successfully drain the water from the tub then a defective main control board could be responsible for the washer not stopping. The main control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Shop all RCA Washing Machine Main Control Board Parts
Less Common

Frequently Asked Questions

Why won't my RCA washer stop running?
Why does my RCA washing machine keep running after it drains?
How do I fix an RCA washer that is stuck on a cycle?
Can I test the timer on an RCA washer that won't stop?
How do I find the correct RCA washer part for this repair?