Choose Product
Identify Problem
03
Find Solutions

Roper Refrigerator not running

If your Roper fridge appears dead or the display and buttons have stopped responding, the most likely culprits are a failed dispenser control board or a problem with incoming power. Start by checking the outlet and circuit breaker, then confirm the plug is fully seated, since a lost power supply is a common cause of a refrigerator control panel not working. If the outlet is good but the display stays dark, inspect the dispenser control board and the user control and display board for burn marks or other damage. Also check the wire harness connectors between the panel and the boards; a loose or damaged harness often looks like an electrical mystery but is an easy fix. After a power surge, a simple power reset can restore operation in some cases. Replacing the main control board is rarely needed, so test the more common parts first before swapping the motherboard. Enter your model number on RepairClinic.com to find the exact replacement part and wiring harness that fits your refrigerator.

01 - Roper Refrigerator Dispenser Control Board

If the refrigerator display appears completely dead, it's possible the dispenser control board has failed. You should inspect the board for any burn marks and replace it if it appears damaged.
Enter model number to search for the required part specific to your product
Highly Likely

02 - Incoming Power Problem

Ensure plug is tightly pushed into a regular electrical outlet and the outlet is supplying power. Using a ground fault outlet for a refrigerator is not recommended. Confirm that no circuit breakers have tripped or fuses have blown.
Highly Likely

03 - Roper Refrigerator User Control and Display Board

If the refrigerator display appears completely dead, it's possible the user control and display board has failed. You should inspect the board for any burn marks and replace it if it appears damaged.
Common

04 - Disconnected or Damaged Wire Harness

The wires from the control panel to the control board may be loose or have become disconnected. Make sure the wire harness connectors are tight. A damaged wire harness will need to be replaced.
Common

05 - Power reset

After a power surge or power outage, refrigerator operation could be temporarily affected. Full operation can sometimes be restored through a power reset by either unplugging the appliance's power cord for a few minutes and then plugging it back in or switching off the circuit breaker for the refrigerator then switching it back on.
Common

06 - Roper Refrigerator Control Board

If nothing is working on the refrigerator, it's likely the control board is defective. However, this is almost never the cause. Before replacing the main control board, test all of more commonly defective parts. If none of the other components are defective, consider replacing the control board.
Less Common

07 - Roper Refrigerator Main Control Board

If nothing is working on the refrigerator, it's likely the main control board is defective. However, this is almost never the cause. Before replacing the main control board, test all of more commonly defective parts. If none of the other components are defective, consider replacing the main control board.
Less Common

Frequently Asked Questions

Refrigerator control panel not working: the display is completely dead. Is it the dispenser control board, user control board, or the main control board?
Refrigerator not cooling and nothing is running: could this be a power or control board problem?
How do I check a disconnected or damaged wire harness causing the control panel or display to fail?
How do I perform a power reset on my refrigerator after a surge or outage?
How do I enter my model number or part number on RepairClinic.com to find the correct replacement part?