Choose Product
Identify Problem
03
Find Solutions

Tappan Dryer steam function not working

If your Tappan dryer steam function is not working or your dryer steam not working when you select Steam Fresh or Steam Sanitize, start by checking the most common electrical failures: when the steam cycle fails to send power to the water inlet valve or steam generator the control board or main control board is usually at fault. The control board is difficult to bench-test, so inspect it for burned components, blown traces, or scorch marks before deciding whether to replace it. If the control board is powering the steam generator but you still get no mist, the steam generator itself is likely defective. Also confirm the water supply hose is connected and the household valve feeding the inlet is open, and check the steam nozzle inside the drum for clogs or damage. If the inlet valve does not release water when energized, test it for continuity with a multimeter and replace it if it fails. Enter your model number on RepairClinic.com to find the exact replacement control board, steam generator, nozzle, or inlet valve for your dryer.

01 - Tappan Dryer Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Enter model number to search for the required part specific to your product
Common

02 - Tappan Dryer Main Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's main control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.
Common

03 - Tappan Dryer Steam Generator

If no power is getting to the dryer's water inlet valve during the steam cycle, but power is reaching the steam generator, then it's likely the steam generator is defective and will need to be replaced.
Common

04 - Water supply not connected.

The water supply hose needs to be connected from the home's water supply to the water inlet valve on the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.
Common

05 - Tappan Dryer Nozzle

The nozzle, normally located at the rear interior of the dryer, may be damaged or clogged with debris and unable to allow the steam to enter the drum area. Inspect the nozzle or any damage or obstruction and replace if necessary.
Less Common

06 - Tappan Dryer Water Inlet Valve

The dryer's water inlet valve provides the water necessary for the steam function to work. If there is no mist coming from the nozzle when the valve is energized, it's likely the inlet valve is defective. You can use a multimeter to test the valve for electrical continuity. If the valve tests negative for continuity, you'll know the part has failed and will need to be replaced.
Less Common

07 - Water Supply Valves are Closed

The water supply valve needs to be turned on to supply water to the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.
Less Common

Frequently Asked Questions

Why is my dryer steam function not working?
How can I test the water inlet valve or steam generator when the steam is not working?
The steam nozzle looks clogged or damaged. How do I inspect and fix it?
Could a bad control board cause the steam function to stop working?
How do I find the right replacement part on RepairClinic.com using my model number or part number?