Crosley Dryer steam function not working

If your Crosley dryer steam function is not working, the most likely culprit is a faulty control board or main control board that is not sending power to the water inlet valve or steam generator. The control board is difficult to test with a meter, but you can remove the console and look for burned traces, scorched connectors, or swollen components to decide if replacement is needed. If the board appears to be supplying power but you still have no steam, the steam generator itself may be bad and will need replacement. Before ordering parts, confirm the dryer’s water supply hose is connected at the shared Y-connector to the washer’s cold-water line, since no water supply will prevent steam. Check the internal nozzle for clogs or damage that would stop mist from reaching the drum. Finally, if the nozzle stays dry when the valve is energized, use a multimeter to test the water inlet valve for continuity; a failed valve will not deliver water. Enter your model number on RepairClinic.com to find the exact replacement part and step-by-step instructions for your dryer.

01 - Crosley Dryer Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.

Enter model number to search for the required part specific to your product

Need help finding your model number?

Shop all Crosley Dryer Control Board Parts

Common

02 - Crosley Dryer Main Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's main control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.

Shop all Crosley Dryer Main Control Board Parts

Common

03 - Crosley Dryer Steam Generator

If no power is getting to the dryer's water inlet valve during the steam cycle, but power is reaching the steam generator, then it's likely the steam generator is defective and will need to be replaced.

Shop all Crosley Dryer Steam Generator Parts

Common

04 - Water supply not connected.

The water supply hose needs to be connected from the home's water supply to the water inlet valve on the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.

Common

05 - Crosley Dryer Nozzle

The nozzle, normally located at the rear interior of the dryer, may be damaged or clogged with debris and unable to allow the steam to enter the drum area. Inspect the nozzle or any damage or obstruction and replace if necessary.

Shop all Crosley Dryer Nozzle Parts

Less Common

06 - Crosley Dryer Water Inlet Valve

The dryer's water inlet valve provides the water necessary for the steam function to work. If there is no mist coming from the nozzle when the valve is energized, it's likely the inlet valve is defective. You can use a multimeter to test the valve for electrical continuity. If the valve tests negative for continuity, you'll know the part has failed and will need to be replaced.

Shop all Crosley Dryer Water Inlet Valve Parts

Less Common

07 - Water Supply Valves are Closed

The water supply valve needs to be turned on to supply water to the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.

Less Common