Electrolux Dryer steam function not working

If your Electrolux dryer steam function is not working, the most likely culprit is a bad control board or main control board that is not sending power to the steam generator or water inlet, so start there and look for burned components or signs of a short. If the control boards are getting power but the drum still gets no steam, the steam generator itself is the next suspect. Less likely causes include a disconnected or blocked water supply line, a clogged or damaged steam nozzle that prevents mist from entering the drum, or a failed water inlet valve that does not open when energized. Whether your symptom reads dryer steam not working, steam fresh not working, or steam sanitize not working, these checks will narrow the problem quickly. If you need a replacement part, enter your model number on RepairClinic.com to see the exact control board, steam generator, nozzle, or inlet valve that fits your dryer and get the part you need to fix it.

01 - Electrolux Dryer Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.

Enter model number to search for the required part specific to your product

Need help finding your model number?

Shop all Electrolux Dryer Control Board Parts

Common

02 - Electrolux Dryer Main Control Board

If no power is getting to either the dryer's water inlet valve during the steam cycle or the steam generator, then it's likely the dryer's main control board is defective and the cause of the steam function problem. The control board cannot be easily tested, but you can try to inspect it for signs of burning or a shorted-out component to help determine if the part should be replaced.

Shop all Electrolux Dryer Main Control Board Parts

Common

03 - Electrolux Dryer Steam Generator

If no power is getting to the dryer's water inlet valve during the steam cycle, but power is reaching the steam generator, then it's likely the steam generator is defective and will need to be replaced.

Shop all Electrolux Dryer Steam Generator Parts

Common

04 - Water supply not connected.

The water supply hose needs to be connected from the home's water supply to the water inlet valve on the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.

Common

05 - Electrolux Dryer Nozzle

The nozzle, normally located at the rear interior of the dryer, may be damaged or clogged with debris and unable to allow the steam to enter the drum area. Inspect the nozzle or any damage or obstruction and replace if necessary.

Shop all Electrolux Dryer Nozzle Parts

Less Common

06 - Electrolux Dryer Water Inlet Valve

The dryer's water inlet valve provides the water necessary for the steam function to work. If there is no mist coming from the nozzle when the valve is energized, it's likely the inlet valve is defective. You can use a multimeter to test the valve for electrical continuity. If the valve tests negative for continuity, you'll know the part has failed and will need to be replaced.

Shop all Electrolux Dryer Water Inlet Valve Parts

Less Common

07 - Water Supply Valves are Closed

The water supply valve needs to be turned on to supply water to the dryer. The water line is usually connected to a “Y” connector and shares the same cold-water supply as the washer. Refer to the owner's manual for water hookup instructions.

Less Common