Frigidaire Induction Range Right Rear Induction Coil Replacement 387404759

Print ContentSave Content

Skill Level

Total Parts Cost

$61.25

Estimated Savings

$112.50

03:50

Description

This video provides step-by-step repair instructions for replacing the right rear induction coil on a Frigidaire induction range. The most common reason for replacing this part is if the coil will not heat.

All of the information for this part replacement video is applicable to the following brands:
Frigidaire

Step By Step Instructions

Print Instructions

Frigidaire Induction Range - GCRI3058AFD

Frigidaire Induction Range Right Rear Induction Coil Replacement

Tools needed: Phillips-head screwdriver, T-20 Torx bit

Shock

Before you begin the procedure, unplug the power cord or shut off the power supply.

Open the oven door and use the Phillips-head screwdriver to unthread the three screws securing the main top.

Heavy

With the screws unthreaded, pull the main top forward to fully remove.

Note the hole locations where the old induction coil retaining clips are inserted into.

Sharp

Detach the coil and move it out of the way.

You will need to mark the hole locations for the right front induction coil as well and detach it to access the rear coil power wire screws.

Note the orientation of the wires then use the T-20 Torx bit to loosen the screws to release the induction coil power wires.

Disconnect the sensor wire from the control module and you can fully remove the old coil.

To install the new induction coil, first connect the sensor wire to the control module.

Slide the power wires under the appropriate screws, then tighten the screws to secure the wires.

Now align the retaining clips with the appropriate holes in the brackets and snap the new coil assembly into position.

Reposition the front induction coil as well.

Reinstall the main top by aligning the sides under the front support bracket, then carefully slide the top back, pressing the induction coils down as you do this.

With the top in place, thread the three screws in front to fully secure it.

Plug the power cord back in or restore the power supply and the induction range should be ready for use.