DescriptionThis video provides step-by-step repair instructions for replacing the main control board on a Frigidaire induction range. The most common reason for replacing this part is if the range will not work at all.
All of the information for this part replacement video is applicable to the following brands:
Frigidaire
Step-By-Step Instructions1
Frigidaire Induction Range - GCRI3058AFD
2
Frigidaire Induction Range Main Control Board Replacement
3
Tools needed: Phillips-head screwdriver, quarter-inch nut driver
5
Before you begin the procedure, unplug the power cord.
7
Have an assistant help you to move the range away from the wall.
8
Use the quarter-inch nut driver to unthread the six screws securing the upper rear access panel.
11
Note the orientation of the wires connected to the control board, then disconnect them.
12
Using the Phillips-head screwdriver, unthread the four mounting screws to release the old board.
13
To install the new control board, properly align it on the mounting brackets and thread the four screws to secure.
14
Connect the wire connecters to the appropriate terminals on the board.
15
Reinstall the upper rear access panel by sliding the tabs under the control panel, then thread the center screw first to hold it in place.
16
Replace the five additional screws to fully secure.
17
Move the appliance back against the wall.
18
Plug the power cord back in and the induction range should be ready for use.