Frigidaire Electric Laundry Center Control Panel Replacement (5304515801)

Print ContentSave Content

Skill Level

Total Parts Cost

$124.23

Estimated Savings

$112.50

05:32

Description

This video provides step-by-step repair instructions for replacing the control panel on a Frigidaire electric washer/dryer laundry center (model FFLE3900UW1). The most common reason for replacing this part is if it is damaged or missing.

This replacement video is applicable to the following brands:
Frigidaire

Don't forget to like and comment on this video and subscribe to our channel!

Step By Step Instructions

Print Instructions

Laundry Center- Model FFLE3900UW1

Laundry Center Control Panel Replacement

"Step 1: Gather a number two square drive bit, a phillips-head screwdriver, and a small flat-head screwdriver. "

Step 2: Unplug the power cord.

Step 3: Use the number two square drive bit or the phillips-head screwdriver to unthread the two screws securing the dryer's lower access panel.

Step 4: Pull the panel up to remove.

Step 5: Unthread the two mounting screws securing the control panel.

Step 6: Pull the panel down to detach.

Step 7: Release the wires from the retaining clip and set the panel on a towel or blanket.

"Step 8: Use the phillips-head screwdriver to unthread the four mounting screws securing the washer's user interface board and the four screws securing the dryer's user interface board. "

Step 9: Pull off both selector knobs.

Step 10: Pull the retaining tabs back to release both boards.

"Step 11: Use the small flat-head screwdriver to pull back the tabs to release both button supports. "

"Step 12: With the supports detached, remove all of the control buttons."

"Step 13: To prepare the new control panel for installation, insert all of the control buttons in the appopriate slots. "

Step 14: Align and snap the two buttons in the appropriate slots.

Step 15: Align both the washer and dryer user interface boards and snap them into position.

Step 16: Rethread all of the screws to secure.

Step 17: Replace both selector knobs.

Step 18: Secure the wires in the retaining clip.

Step 19: Position the control panel.

Step 20: Replace the mounting screws.

Step 21: Realign the access panel and secure it with the screws.

Step 22: Plug the power cord back in.

Congratulations! Your laundry center should be ready for use.