KitchenAid Dishwasher Control Panel Replacement #W10891913

Total Parts Cost

$NaN

04:04

Description

This video provides step-by-step repair instructions for replacing the control panel on KitchenAid dishwasher model #KDTE204EPA3. The most common reason for replacing the panel is if it is damaged.

All of the information for this control panel replacement video is applicable to the following brands:
Kenmore, KitchenAid, Whirlpool, Ikea, Amana, Jenn Air, Maytag

Tools needed: 1/4" nut driver, Channel Lock pliers, phillips head screwdriver

Step By Step Instructions

Print Instructions

Anncr: repairclinic makes fixing things easy…

…with millions of replacement parts available on our website…

…and the help you need to do the repair yourself.

Since we encourage you to perform this repair safely, a warning icon will appear when you should use caution.

Before you replace the control panel on your dishwasher…

…be sure to turn off the power to the appliance.

Use a t-15 torx bit to unthread the four screws securing the custom outer door panel to the metal door panel.

The screws at located at the top corners…

…and second from the bottom on the left and right sides.

Lift the custom outer panel up to fully detach and set it aside.

Next, unthread the remaining screws securing the metal door panel to the inner panel.

Remove the retaining pin.

Now pull the door panel forward and lift up to remove.

Unthread the door latch mounting screws.

You can now lift the old control panel off and disconnect the touch-pad wire harness from the control board to fully remove.

Prepare the new control panel for installation…

…by first making sure the control board shield is in place.

Now connect the provided touch-pad wire harness to the panel.

Connect the opposite end of the wire harness to the control board.

Align the new control panel on the inner door panel…

…and thread the door latch mounting screws to secure.

Reinstall the outer metal door panel by sliding it over the mounting tabs and aligning it with the inner panel.

Insert the retaining pin to help hold the panel in place.

Rethread the screws to secure.

Reinstall the custom outer panel by inserting the mounting studs into the key-hole slots.

Slide the panel down until the top of the custom panel is flush with the top of the control panel.

Replace the four screws to secure the panel.

With the repair completed…

…turn the power supply back on…

…and your dishwasher should be ready for use.

At repairclinic – we make fixing things easy.

Thank you for supporting the production of these videos by purchasing your parts from our website.