Honda Small Engine Carburetor Choke Control #16600-Z8B-900

Total Parts Cost

$NaN

02:40

Description

This video provides step-by-step instructions for replacing a choke control on Honda small engines. The most common reason for replacing a control is if it is damaged or missing.

All of the information in this choke control replacement video is applicable to the following brands: Honda

Tools used: 10mm socket

Step By Step Instructions

Print Instructions

Before you replace the choke control assembly on your engine first make sure the engine has cooled.

Next, you should remove the wire and boot from the spark plug to prevent the engine from accidentally starting.

Press the retaining tabs down to release the air housing cover and set the cover and air filter aside

Use a 10mm socket to unthread the mounting bolts securing the air filter housing and carburetor.

Remove the loose components.

Before you install the new choke control assembly insert the bolts through the air filter housing.

Slide on the air cleaner gasket followed by the carburetor.

Now slide on the air guide gasket followed by the new choke control assembly.

Slide on the intake gasket then thread the bolts into the engine and tighten to secure.

Replace the air filter in the housing then align the lower cover tabs with the housing and snap the upper tabs into place.

With the repair completed reattach the wire and boot to the spark plug and your engine should be ready for use.